Rgblink VSP 3600 User Manual Manual de usuario descargar pdf (Pagina 124)

7. Common Questions and Solution

VSP 3600 User Manual 124

No Output in Large Screen

Confirm if there are any input singles

Press 【MENU】to find "Device information" , check if the INPUT signal is

normal via 【 NEXT 】, if suggest "NO INPUT", means no signal. Check

the front-end signal line, please note do double show or expand for

computer. Can enter other formats signal to do the same operation.

Confirm if single output

Find a belt VGA input (best for DVI) display, connect to the corresponding

output port of processor, check whether the signal is correct on the

monitor. If not display properly, please check whether there is input signal,

or if input wire interface is taken tight, output wire interface is picked up

tightly. If display normally, check if sending card is normally working or

need to replace sending card test.

Large Screen Output Flash Point

Confirm if preview output is normal

Find a belt VGA input (best for DVI) display, connect to the corresponding

output port of processor, check whether the signal is correct on the

monitor. If display normally shows and no flash point, please check

whether DVI outlets put tight or replace to DVI line of sending card. If

display flash point, please judge if input signal, wire, and interface is

normal.

Large Screen only Display Part of the

Image

Signal need to scale

Press 【Scale】, rotate the knob to adjust the size of screen size, including

"Width", "Height" etc. Press【NEXT】to confirm.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 132 133

Sin comentarios

Rgblink VSP 3600 User Manual Manual de usuario Pagina 124